BajaNomad
Not logged in [Login - Register]

Go To Bottom
Printable Version  
Author: Subject: A question about wheel adapters
AKgringo
Elite Nomad
******




Posts: 6017
Registered: 9-20-2014
Location: Anchorage, AK (no mas!)
Member Is Online

Mood: Retireded

[*] posted on 11-28-2023 at 04:24 PM
A question about wheel adapters


Sorry about the false start! I have an older GM based van conversion (2wd) that I want to do a little "Van lifeing" in. It has 8 lug16.5 inch rims that I want to replace before I hit the road.

I have found several sets of newer 8 lug rims and tires, but my measurement tells me that I would need to use 1 1/2 inch spacers to get proper clearance. Possibly some older 8 lug 16 inch rims would work, but the ones I have found so far have been junk. (cost matters as well)

While searching for spacers I found that for a few dollars more, I can get 2 inch thick units that would allow me to use a set of Tacoma six lug rims and tires that I already have.

It is a pretty light rig so would it be unsafe for any reason to run the Tacoma rims?

[Edited on 11-28-2023 by AKgringo]




If you are not living on the edge, you are taking up too much space!

"Could do better if he tried!" Report card comments from most of my grade school teachers. Sadly, still true!
View user's profile
Almost
Junior Nomad
*




Posts: 29
Registered: 1-18-2022
Member Is Offline


[*] posted on 11-28-2023 at 04:28 PM


What's the question?
View user's profile
RFClark
Super Nomad
****




Posts: 2457
Registered: 8-27-2015
Member Is Offline

Mood: Looking forward to 2024

[*] posted on 11-28-2023 at 08:57 PM


A problem you encounter if you space the wheels out is that you put more strain on the front axles. This makes the possibility of a front axle failure on bad potholed Baja roads more likely. You might be able to find heavier front end parts designed for the greater forces caused by those 2 extra inches.

Just a thought.

[Edited on 11-29-2023 by RFClark]
View user's profile
pacificobob
Super Nomad
****




Posts: 2304
Registered: 4-23-2006
Member Is Offline


[*] posted on 11-28-2023 at 09:45 PM


I'm not a fan of wheel adapters. they may work well enough, but handling and load capacity likely won't be improved.
View user's profile
BooJumMan
Senior Nomad
***




Posts: 895
Registered: 8-11-2007
Location: San Diego
Member Is Offline


[*] posted on 11-29-2023 at 07:04 AM


First thing, look up the load rating on your current Tacoma wheels. There should be some stampings on the back you can look up. Make sure they are comparable to the load rating of your van wheels. Same goes with the tires.

Wheel adapters -- Its a hot button topic. I've run them on most my Baja rigs for the last 20 years w/o failure or issues (knock on wood!). I buy higher quality ones. There is no difference in stresses on the wheel bearings or ball joints between a using a 2 inch wheel adapter vs a wheel with a 2 inch outboard offset. The issues usually arise with runout tolerances of the machined surfaces causing vibrations. This is usually found with poor quality sets.

Most the name brand wheels these days are running less backspacing which suck the wheels in and cause the tires to rub suspension/frame. You should be able to find some lesser known brands catered to offroading with better offsets. The GMC van uses a 6 x 5.5 bolt pattern? If so, you will have a ton of options across both Toyota Chevy/GMC.




In that pre-Google Earth and social media epoch, The Code was adhered to. It was based on a simple verity: if a locale had been transformational for you, and you had put the hard yards in to get there and to learn it, to know it, why in god�s name would you broadcast the news, thus ruining the future experience not only for yourself, but for future adventurers?
View user's profile
AKgringo
Elite Nomad
******




Posts: 6017
Registered: 9-20-2014
Location: Anchorage, AK (no mas!)
Member Is Online

Mood: Retireded

[*] posted on 11-29-2023 at 12:49 PM


Good points, I intend to stay with tires and rims that are light truck rated. I think the rims are actually from a Toyota Tundra, and one thing I like about that is that if necessary, finding a replacement in Baja would be easier than a lot of other options.

My next step is to find out just what the actual weight of the rig is. The wheels (8 lug) and running gear appear to be one ton hardware, but I can't imagine this conversion would be heavier than a half ton pickup with a camper unit.

To replace the stock wheels with newer units I will need at least 1 1/2 inch spacers, and two inches could allow wider tires.




If you are not living on the edge, you are taking up too much space!

"Could do better if he tried!" Report card comments from most of my grade school teachers. Sadly, still true!
View user's profile

  Go To Top

 






All Content Copyright 1997- Q87 International; All Rights Reserved.
Powered by XMB; XMB Forum Software © 2001-2014 The XMB Group






"If it were lush and rich, one could understand the pull, but it is fierce and hostile and sullen. The stone mountains pile up to the sky and there is little fresh water. But we know we must go back if we live, and we don't know why." - Steinbeck, Log from the Sea of Cortez

 

"People don't care how much you know, until they know how much you care." - Theodore Roosevelt

 

"You can easily judge the character of others by how they treat those who they think can do nothing for them or to them." - Malcolm Forbes

 

"Let others lead small lives, but not you. Let others argue over small things, but not you. Let others cry over small hurts, but not you. Let others leave their future in someone else's hands, but not you." - Jim Rohn

 

"The best way to get the right answer on the internet is not to ask a question; it's to post the wrong answer." - Cunningham's Law







Thank you to Baja Bound Mexico Insurance Services for your long-term support of the BajaNomad.com Forums site.







Emergency Baja Contacts Include:

Desert Hawks; El Rosario-based ambulance transport; Emergency #: (616) 103-0262