Ron_Perry - 3-28-2010 at 07:50 PM
I could not fire up my hot water heater on our last camping trip, on our new (to us, 2005) tent trailer. At home, as I tried to fire it up, and
inspect it, I noticed two wires on the backside of the "control start switch". These wires are both white, about 18 gauge....The problem seems to
be....zero gas to the unit when the pilot switch is depressed.....all other gas appliances work great ( heater, inside and outside stove).
Could these two wires be attached to a on/off float switch? I do not have a manual for the unit. Thanks for any advice or help, Ron
arrowhead - 3-28-2010 at 08:17 PM
Without knowing what unit/fuel your are using, I can only give you a general suggestion. One of the most common problems is dead bugs inside your
plumbing. Take it apart and clean all the fuel piping and the regulator. The fuel pressure in propane units is very low -- about 2.5 psi -- so the gas
won't get by any blockage.
DENNIS - 3-28-2010 at 08:39 PM
Common problem when they sit dormant for any length of time. The thermocouple will need to be changed. Nothing to worry about.
http://www.ehow.com/how_2070305_replace-gas-water-heater-the...
Ron_Perry - 3-28-2010 at 09:07 PM
Thanks! That was quick. I'll look into both tips, Ron