fishhead - 1-11-2015 at 05:40 PM
Please assist our local artisan with help acquiring a small electric motor for sanding and cutting. 1 to 1 1/2 hp should be fine. U2u me for info,
thanks.....
MulegeAL - 1-12-2015 at 05:04 PM
Is he doing direct-drive of his blades on long or a double-ended motor shaft or is his setup belt-driven to an arbor? I can't remember what he has,
other than a few fingers left! Amazing guy.
Sorry, me no hay motor, will ask/look around.
Would an old 5 hurricane washer motor suffice? Might need bearings, Marcos could do that. But not sure its available. Or, ask Marcos what he has
in in motor pile that could be rebuilt.
Bruce R Leech - 1-12-2015 at 05:58 PM
1650 or 3600 RPM?
fishhead - 1-13-2015 at 10:14 AM
3600
bajaguy - 1-13-2015 at 10:26 AM
http://www.harborfreight.com/3-horsepower-compressor-duty-mo...
chivatojoe - 1-13-2015 at 10:43 PM
I already ordered and received one for Jose Morales. I did a carving trade with him a 1.5 horse. Just have to get to him in a couple of weeks if you
should see him
motor
fishhead - 1-15-2015 at 05:13 PM
got one to him yesterday thanks for all the suggestions....