LukeJobbins - 12-3-2018 at 09:33 PM
I need a machine shop in rosarito or primo tapia or near. I need to drill out steering knuckles to 7/8" and my drill bit broke. Its a bigger, not
normal size for a hardware store, drill bit so a machine shop that could finish the job with a drill press or preferably a mill is preferred, but at
this point I will take anything. HELP! I really don't want to drive up to tijuana for a five minute job.
Terry28 - 12-4-2018 at 11:05 AM
Try Leon in Primo Tapia....American, great mechanic....661-110-1346
willardguy - 12-4-2018 at 11:36 AM
if you haven't solved this issue.....there's an industrial supply that's never failed me. north end of benny juarez across the street from the
Coppel, the one next to carls jr/auto zone. super nice folks, speak perfect english, they'll probably have the bit or know where to send you
LukeJobbins - 12-4-2018 at 12:10 PM
Roger. I was recommended a shop in rosarito and they said yeah no problem and took it in the back. They brought me back a wobbled out lopsided hole
almost an 1/8” bigger than I need. Not good for a high tolerance part. So...off to the junkyard I go to get a new part then I’ll try to get ahold
of Leon or a new bit.