BajaNomad
Not logged in [Login - Register]

Go To Bottom
Printable Version  
 Pages:  1  2
Author: Subject: ON-DEMAND GAS WATER HEATERS - NOT
rob
Senior Nomad
***




Posts: 509
Registered: 10-19-2004
Location: Pacific Coast, BCS
Member Is Offline


[*] posted on 4-13-2008 at 09:22 AM


Lencho - like so many things here at the ranch - we make it up as we go along. In retrospect, an engine-driven welder would have made a lot of sense (and its something we will probably get as we start the planned development).

Right now, its cheaper just to leave the 3-phase where it is and keep usage to a minimum!

Not for the first time, I wish I had been a builder/mechanic rather than a computer salesman!




View user's profile
Taco de Baja
Super Nomad
****


Avatar


Posts: 1913
Registered: 4-14-2004
Location: Behind the Orange Curtain, CA
Member Is Offline

Mood: Dreamin' of Baja

[*] posted on 4-13-2008 at 10:05 AM


The Bosch Aquastar with battery ignition I had in San Juan Capistrano on HARD well water. was a POS.

At low flow volume it would not ignite.
If you had more than one faucet running neither one would get very hot water.
The 2 D batteries worked ok for the first year, then I had to replace at 6 months, then 2 months then every month! Even though a volt meter said they were putting out 1.1 or more volts each. I eventually hard wired a 3 volt plug in AC/DC converter to the thing, ind of defeating the whole energy saving aspect.....

The reason for a longer flue vent is more efficient burning. In a fire place, the taller the chimney, the better the draw of O2 from the room; I think the sane is true for gas water heaters.




Truth generally lies in the coordination of antagonistic opinions
-Herbert Spencer
View user's profile
vandenberg
Elite Nomad
******




Posts: 5118
Registered: 6-21-2005
Location: Nopolo
Member Is Offline

Mood: mellow

[*] posted on 4-13-2008 at 11:57 AM


Quote:
Quote:


My Bosc was bought in US for $1100 + another 200 for stainless steel flue pipe. It has electronic ignition using 110 + transformer. I hear the battery powered ignition units they sell in MX eat batteries. Also, based on photo you really need to extend flue pipe. Bosc says min length is 4 foot and cap needs to be 1 foot higher than anything within 10 foot around it.:bounce:



In my previous post I referred to my 2 40 gallon conventional propane waterheaters. Have been going since 1991 without ever any problem, and still going strong. At $ 189.00 each, it will take a lot of convincing to go to your Bosch on demand unit at the cost you state.


[Edited on 4-13-2008 by vandenberg]




I think my photographic memory ran out of film


Air Evacuation go to
http://www.loretobarbara@skymed.com
View user's profile
BMG
Super Nomad
****




Posts: 1776
Registered: 6-10-2007
Location: La Paz / Bahia Asunci�n / Away from home
Member Is Offline


[*] posted on 4-13-2008 at 12:30 PM


Quote:
Quote:
Quote:
Originally posted by vandenberg


My Bosc was bought in US for $1100 + another 200 for stainless steel flue pipe. It has electronic ignition using 110 + transformer. I hear the battery powered ignition units they sell in MX eat batteries. Also, based on photo you really need to extend flue pipe. Bosc says min length is 4 foot and cap needs to be 1 foot higher than anything within 10 foot around it.:bounce:



In my previous post I referred to my 2 40 gallon conventional propane waterheaters. Have been going since 1991 without ever any problem, and still going strong. At $ 189.00 each, it will take a lot of convincing to go to your Bosch on demand unit at the cost you state.


[Edited on 4-13-2008 by vandenberg]


Still much too early to tell if going with the tankless heater was a good move or not, but I'm sure I wouldn't have done it if the cost had been anywhere near U$1100. As it was, the cost of a replacement 15 gal electric heater was within U$30 of the demand heater. Won't be hard to switch back to a conventional water heater again if we need to. So far, zero problems with the pilotless Bosch (knock on cinder block.)

Very little noticeable change in temperature when one of the other faucets is used or a toilet flushed. We do have a pressure system on our lines with a range of 30 - 50 psi. I doubt the heater would operate well, if at all, on gravity feed water pressure.

I'm not convinced that I need to extend the flue. Nice blue flame when it's operating. With the big open side vents, it looks like you could run the unit with vent cap totally sealed off. Even that paper UPS sticker is stick like new on the flue cap. I'm going to leave well enough alone for now and go take a loooonnnngggg hot shower.:spingrin: (Just kidding, I've had my weekly shower already.)




I think the world is run by C- students.
View user's profile
 Pages:  1  2

  Go To Top

 






All Content Copyright 1997- Q87 International; All Rights Reserved.
Powered by XMB; XMB Forum Software © 2001-2014 The XMB Group






"If it were lush and rich, one could understand the pull, but it is fierce and hostile and sullen. The stone mountains pile up to the sky and there is little fresh water. But we know we must go back if we live, and we don't know why." - Steinbeck, Log from the Sea of Cortez

 

"People don't care how much you know, until they know how much you care." - Theodore Roosevelt

 

"You can easily judge the character of others by how they treat those who they think can do nothing for them or to them." - Malcolm Forbes

 

"Let others lead small lives, but not you. Let others argue over small things, but not you. Let others cry over small hurts, but not you. Let others leave their future in someone else's hands, but not you." - Jim Rohn

 

"The best way to get the right answer on the internet is not to ask a question; it's to post the wrong answer." - Cunningham's Law







Thank you to Baja Bound Mexico Insurance Services for your long-term support of the BajaNomad.com Forums site.







Emergency Baja Contacts Include:

Desert Hawks; El Rosario-based ambulance transport; Emergency #: (616) 103-0262