Doug/Vamonos
Nomad
Posts: 417
Registered: 6-19-2006
Location: Bahia de los Angeles
Member Is Offline
|
|
Advice on garage roof please
Hi. I'm building a new place in LA Bay. My garage is 16' x 24'. The roof will be plywood with the standard rolled roofing. The pitch is minimal - a
little over 1/4" per foot. Pretty much what every other garage looks like that I have seen. In previous builds I've just rolled the material in place,
nailed it every foot, and sealed the edges and overlapping seams with Henry's roofing adhesive. Seems to work fine. But would it be better to hotmop
the plywood first to enhance the durability in case water or moisture gets past? Actually I wouldn't hotmop with the hot aphalt but use one of the
roofing primer sealants that I find at home Depot. Or am I over-engineering this? Does anyone use a propane torch to adhere the roofing? Thanks.
|
|
|
rts551
Elite Nomad
Posts: 6699
Registered: 9-5-2003
Member Is Offline
|
|
Have you ever considered using a metal roof. At least over on the Pacific side, Punta ABreojos, the rolled roofing never seems to last long.
|
|
|
David K
Honored Nomad
Posts: 64854
Registered: 8-30-2002
Location: San Diego County
Member Is Offline
Mood: Have Baja Fever
|
|
Suggest you talk to Bedman (Camp Gecko) as his roof-over set up looks pretty solid.
|
|
|
DENNIS
Platinum Nomad
Posts: 29510
Registered: 9-2-2006
Location: Punta Banda
Member Is Offline
|
|
Don't hotmop the plywood. If in the future you want to re-roof for whatever reason, you won't be able to.
Torch-down roofing works super well, but practice first. It can be unforgiving.
I just did another roof with lap-cement. It works well as long as the base is straight and smooth. Roll roofing shows most uneven imperfections
below the surface.
If not too late, maybe add a bit of pitch to the roof. The faster water runs off, the longer the surface will last.
Are you sure 16 feet is deep enough? Better measure your vehicle.
"YOU CAN'T LITTER ALUMINUM"
|
|
|
woody with a view
PITA Nomad
Posts: 15939
Registered: 11-8-2004
Location: Looking at the Coronado Islands
Member Is Offline
Mood: Everchangin'
|
|
Use roof felt first. If you never want to worry about it look up TPO roof membrane.
|
|
|
larryC
Super Nomad
Posts: 1495
Registered: 8-11-2008
Location: BoLA
Member Is Offline
|
|
I have used rolled roofing in the past and if done right it will last 10 years or so. Less time if not done right. The last garage I did in metal,
easier and lasts a lot longer.
Off grid, 12-190 watt evergreen solar panels on solar trackers, 2-3648 stacked Outback inverters, 610ah LiFePo4 48v battery bank, FM 60 and MX60
Outback charge controllers, X-240 Outback transformer for 240v from inverters, 6500 watt Kubota diesel generator.
|
|
|
Russ
Elite Nomad
Posts: 6742
Registered: 7-4-2004
Location: Punta Chivato
Member Is Offline
|
|
We use maxiteja (sp). It's a composite material that comes in 1 meter by 2 meter sheets and is screwed down to the plywood or rafters. we use to be
able to buy 1 meter by 6 meter or longer sheets of the same material we called lamina. Note the above about plywood quality whether you use rolled
roofing or other material bad / cheap plywood can really cost a lot to replace. Here are some photos of my patio roof. My garage is the same using
lamina. So far no storm has done any damage. I wrapped the patio roof in front for a little shade during the sunrise. I think it also helps break the
storm winds.
Bahia Concepcion where life starts...given a chance!
|
|
|
willardguy
Elite Nomad
Posts: 6451
Registered: 9-19-2009
Member Is Offline
|
|
Quote: Originally posted by rts551  | | Have you ever considered using a metal roof. At least over on the Pacific side, Punta ABreojos, the rolled roofing never seems to last long.
|
I'll go with ralph, after 10 years our galvanized roof (the whole house is metal) looks exactly the same as when it was built, (this is on the cortez
side)
|
|
|
AKgringo
Elite Nomad
Posts: 6029
Registered: 9-20-2014
Location: Anchorage, AK (no mas!)
Member Is Offline
Mood: Retireded
|
|
The OP stated that he only has a 1/4 inch per foot drainage. Since there is almost 100% chance that the rafters will sag at some point, drainage is a
real problem in a downpour.
I feel that an impervious membrane is mandatory either as a roof surface, or under it.
If you are not living on the edge, you are taking up too much space!
"Could do better if he tried!" Report card comments from most of my grade school teachers. Sadly, still true!
|
|
|
Doug/Vamonos
Nomad
Posts: 417
Registered: 6-19-2006
Location: Bahia de los Angeles
Member Is Offline
|
|
Thanks for your input. In our campo everyone builds a strong roof to place a pila/tanque/tinaco (whichever is your preference) on top. I will also
mount a dozen solar panels up there and occasionally sleep up there. I weigh 230lbs and my dog weighs 85lbs so it needs to support all of these
things. So the steel (can't walk and sleep on it) and the plastic doesn't work in my case. I think I'll increase the pitch and add a layer of roof
felt under it like Woody suggests.
[Edited on 8-24-2016 by Doug/Vamonos]
|
|
|
woody with a view
PITA Nomad
Posts: 15939
Registered: 11-8-2004
Location: Looking at the Coronado Islands
Member Is Offline
Mood: Everchangin'
|
|
I had to seal around the water tank since water has found its way thru under it. just some stains on the joists, nothing major. two tubes of Henrys.
the rest of it is holding up nicely.
use felt-it adds a layer of cushion for those nail heads that don't get pounded down flush.
|
|
|
Bob53
Senior Nomad
Posts: 661
Registered: 2-24-2014
Location: Fallbrook, CA & Bahia de los Angeles
Member Is Offline
|
|
Afterwards, put a couple coats of white elastomeric roof coating and that will extend the life of your roof and deflect a large amount of sun's heat.
http://www.homedepot.com/p/Henry-4-75-Gal-587-White-Roof-Coa...
The bitterness of poor quality remains long after the sweetness of low price is forgotten.
|
|
|
larryC
Super Nomad
Posts: 1495
Registered: 8-11-2008
Location: BoLA
Member Is Offline
|
|
| Quote: Originally posted by Doug/Vamonos | Thanks for your input. In our campo everyone builds a strong roof to place a pila/tanque/tinaco (whichever is your preference) on top. I will also
mount a dozen solar panels up there and occasionally sleep up there. I weigh 230lbs and my dog weighs 85lbs so it needs to support all of these
things. So the steel (can't walk and sleep on it) and the plastic doesn't work in my case. I think I'll increase the pitch and add a layer of roof
felt under it like Woody suggests.
[Edited on 8-24-2016 by Doug/Vamonos] |
You didn't mention in the original post that you wanted a water tank and a patio on your roof. Maybe a torch down roof will work for you. Ask Robt and
Pam over at beach Bob's old place what they had to do to get a water proof roof. As I remember it was lots of rolled roofing and tar.
Off grid, 12-190 watt evergreen solar panels on solar trackers, 2-3648 stacked Outback inverters, 610ah LiFePo4 48v battery bank, FM 60 and MX60
Outback charge controllers, X-240 Outback transformer for 240v from inverters, 6500 watt Kubota diesel generator.
|
|
|
mtgoat666
Select Nomad
Posts: 18386
Registered: 9-16-2006
Location: San Diego
Member Is Offline
Mood: Hot n spicy
|
|
Last time I built a water proof deck, I used a paint-on (via roller) material (over quality plywood deck) that was waterproof and walkable (it went on
in 2 coats, set up with flexibility like rubber, and had some additive that provided surface roughness for traction). Don't remember the name of it,
bit it held up for over 20 years in direct sun and weather.
If you want a walking surface, use the specialty products made for foot traffic. The normal roof products are not intended for frequent foot traffic.
Put your solar mounts on first so your roofing product is properly incorporated with flashing.
If not using the roof as a deck, then increase the pitch, and 99 percent of your leak risks will go away.
| Quote: Originally posted by larryC | | Quote: Originally posted by Doug/Vamonos | Thanks for your input. In our campo everyone builds a strong roof to place a pila/tanque/tinaco (whichever is your preference) on top. I will also
mount a dozen solar panels up there and occasionally sleep up there. I weigh 230lbs and my dog weighs 85lbs so it needs to support all of these
things. So the steel (can't walk and sleep on it) and the plastic doesn't work in my case. I think I'll increase the pitch and add a layer of roof
felt under it like Woody suggests.
[Edited on 8-24-2016 by Doug/Vamonos] |
You didn't mention in the original post that you wanted a water tank and a patio on your roof. Maybe a torch down roof will work for you. Ask Robt and
Pam over at beach Bob's old place what they had to do to get a water proof roof. As I remember it was lots of rolled roofing and tar.
|
|
|
|
Chrish22
Newbie
Posts: 1
Registered: 4-12-2017
Member Is Offline
|
|
I just completed roof repairing campaign under the expert guidance of Robbie Malan, and now I feel safe to move into my home with kids and family, once again.
|
|
|
Phil C
Senior Nomad
Posts: 564
Registered: 3-27-2004
Location: N. San Diego County/ Loreto Centro/Lopez Mateos
Member Is Offline
|
|
Find a roofer, take him fishing.........
Check your U2U
[Edited on 4-12-2017 by Phil C]
|
|
|
Doug/Vamonos
Nomad
Posts: 417
Registered: 6-19-2006
Location: Bahia de los Angeles
Member Is Offline
|
|
Old post. Came out fine. Thanks.
|
|
|
DENNIS
Platinum Nomad
Posts: 29510
Registered: 9-2-2006
Location: Punta Banda
Member Is Offline
|
|
I was going to say, use this stuff, but as mentioned....old thread, and I already did:
http://us.henry.com/roofing/adhesives-and-primers/203-cold-a...
"YOU CAN'T LITTER ALUMINUM"
|
|
|
![[*]](images/xmbforum/default_icon.gif){kind=icon}
